Problems with dismantling and folding of inflatable boats

If the inflatable is not stored well after use, it will affect future use and may cause damage to the inflatable. Inflate the deck and inflate the buoyancy tube and you can immediately carry your family and friends for a fishing trip or a ride on the sea. Inflatable boats an inflatable boat, mostly made of rubber, hence the name. It can be compressed without being inflated. It is driven by a motor or human power. It can be used for recreational races and water rescues, and is also used by marines in various countries. Disassemble and fold the inflatable boat in the right way. Inflatable boatAn inflatable boat, mostly made of rubber, hence the name rubber boat. Uninflated can be compressed. Powered by motor or human power. It can be used for recreational races as well as water rescue and other purposes. The following describes the disassembly and folding of the inflatable boat.

1. When dismantling the boat, choose a relatively flat ground, clean up any hard objects nearby, and pay attention to the cleanliness and dryness of the hull.

2. Disassemble the boat's oars and additional accessories on board, and open all air valves (press down on the air valve spool in a clockwise direction, rotate it slightly to lock the air spool and release most of the gas).

3. if flooring a wooden or aluminium boat, remove the flooring by removing the tabs on the sides, then remove the flooring by placing the blocks.

4. use your foot to pull the air out of every air pocket on the boat.

5. lay the hull, folding the sides of the boat inwards and folding the stern to the bow.

6. fold and place in storage bags and select the right safe storage area.

Before folding the dinghy, rinse the outside dry with water to remove sand and ash, open the inflatable valve to release the air in the airbag, collect other accessories outside the boat, lay the dinghy flat, it is recommended to fold both sides inwards, fold from the bow direction to avoid degumming and opening the protective tape, reduce the volume after closing the boat.

If conditions permit, the dinghy is stored by two-thirds air when not in use. If the folds remain for a long time, the folds may be degummed and airtight.